End Devices (Nodes)   Hardware


Topic Replies Activity
Super cheap LoRa node with PCB antenna 18 May 24, 2019
Grasshopper custom pin mapping 2 May 22, 2019
The Things Node Battery consumption 12 May 22, 2019
Rhf76-052am - getting it working with OTAA 68 May 20, 2019
Murata EndDevice development board 4 May 20, 2019
LoRa-LoRa - Getting much poorer-than-expected range 5 May 19, 2019
Range Test, between gateway and node 8 July 13, 2019
How To Restrict 915MHz Frequency Range for Australia 7 May 10, 2019
RFM95W only working at very short ranges 3 May 9, 2019
Solar power lora node, no battery 15 July 7, 2019
OTAA joining issue 11 July 6, 2019
How to register ZENNER EASY PROTECT smoke detector to TTN 15 July 5, 2019
Agriculture: Anyone doing this? What/How/Why? 26 July 3, 2019
Anyone tried Laird RM1XX modules ? part 2 159 May 1, 2019
Watercourse and water level - any good experience? 6 June 30, 2019
Same Fport used by different devices 3 June 28, 2019
Meter Reading 13 June 23, 2019
Trying to create a node with a Cytron Shield-LoRa-RFM on Arduino Uno 9 May 1, 2019
New board by Elecrow 12 April 19, 2019
DIYmall LoRa32u4 II 24 April 14, 2019
Solar Powered Low Cost LoRa Node with Integrated Battery Holder 14 April 13, 2019
RN 2483A Frame counter resets randomly 4 June 10, 2019
No device is found by Lora Development Utility 3 June 10, 2019
LoRaMac Node with OTAA + ADR - Current Consumption 3 June 7, 2019
Production ready accurate humidity nodes, CE, IP65 (Europe)? 12 April 5, 2019
OTAA Join status showing NOT_JOINED after power cycle RN2483 21 May 31, 2019
Low cost ready-to-use outdoor temperature sensor kit for larger deployments? 28 May 26, 2019
Problem with ic880a or node 7 May 18, 2019
Arduino MKR 1300 not connect at the Gateway to 1 km 8 May 17, 2019
Lora network to measure water consumption 7 May 13, 2019