# ATTiny LoRa Nodes **URL:** \ **Category:** Hardware\ **Created:** [October 9, 2019, 11:01pm UTC](https://www.thethingsnetwork.org/forum/t/attiny-lora-nodes/30629 "2019-10-09T23:01:30Z")\ **Posts on this page:** 1\ **Showing post:** 22
**Author:** ![tomtor](https://www.thethingsnetwork.org/forum/user_avatar/www.thethingsnetwork.org/tomtor/32/47264_2.png) [@tomtor](https://www.thethingsnetwork.org/forum/u/tomtor)\ **Post date:** [August 22, 2021, 7:42am UTC](https://www.thethingsnetwork.org/forum/t/attiny-lora-nodes/30629/22 "2021-08-22T07:42:35Z")
> [@descartes](#): > > Cool - with the right settings you can get MCC LMIC 3.3.0 on to that with room for a couple of sensors. Sadly I can’t find any 3216’s at present as I was going to make a design for that. It’s not really an ATtiny, but it is quite compatible and not expensive: > [@AVR128DB28 PCB with RFM95](https://www.thethingsnetwork.org/forum/t/avr128db28-pcb-with-rfm95/50864): > > I made a PCB for the STM32 about 4 years ago: [https://www.thethingsnetwork.org/labs/story/a-cheap-stm32-arduino-node](https://www.thethingsnetwork.org/labs/story/a-cheap-stm32-arduino-node), but because these boards are hard to get nowadays I recently designed a PCB with the AVR128DB28. These are inexpensive (about 2€) and have a modern architecture, compatible with the ATtiny3216 and ATtiny1614, but with 128 kBytes flash. [AVR-LORA] My design is an SMD design (large 1206 but easy to change to 0805) because I have recently overcome my fear of hand soldering these c… --- _[View the full topic](https://www.thethingsnetwork.org/forum/t/attiny-lora-nodes/30629)._