# Big ESP32 / SX127x topic part 1

**URL:** <https://www.thethingsnetwork.org/forum/t/big-esp32-sx127x-topic-part-1/10247>\
**Category:** End Devices (Nodes)\
**Created:** [October 24, 2017, 4:39pm UTC](https://www.thethingsnetwork.org/forum/t/big-esp32-sx127x-topic-part-1/10247 "2017-10-24T16:39:55Z")\
**Posts on this page:** 1\
**Showing post:** 127

<div class="post-metadata">

**Author:** ![Mirtcho](https://www.thethingsnetwork.org/forum/user_avatar/www.thethingsnetwork.org/mirtcho/32/7669_2.png) [@Mirtcho](https://www.thethingsnetwork.org/forum/u/Mirtcho)\
**Post date:** [December 3, 2017, 7:53pm UTC](https://www.thethingsnetwork.org/forum/t/big-esp32-sx127x-topic-part-1/10247/127 "2017-12-03T19:53:32Z")

</div>

Does somebody has the documentation of this board.  
I received mine. As far as I understood the small- coil soldered antenna is for WIFI / BT while the IPX connector is for LoRa.  
Now the tricky part - The Lora receive level with or without attached antenna are the same - 108dbm  
I have used

1. IPX-SMA cable 15…20cm - [https://www.ebay.com/itm/20cm-RG178-Cable-RP-SMA-Female-Plug-Bulkhead-To-IPX-U-FL-Coax-Pigtail-8in-BS1/262569476561?hash=item3d225c41d1:g:xmYAAOSwoydWm9xh](https://www.ebay.com/itm/20cm-RG178-Cable-RP-SMA-Female-Plug-Bulkhead-To-IPX-U-FL-Coax-Pigtail-8in-BS1/262569476561?hash=item3d225c41d1:g:xmYAAOSwoydWm9xh)

2. this type of antenna - [https://www.ebay.com/itm/4pcs-lot-Ebyte-868mhz-TX868-JZ-5-2-5dBi-high-gain-SMA-Male-rf-rubber-antenna/192237275389?hash=item2cc23c08fd:g:dpsAAOSw2xRYYxVt](https://www.ebay.com/itm/4pcs-lot-Ebyte-868mhz-TX868-JZ-5-2-5dBi-high-gain-SMA-Male-rf-rubber-antenna/192237275389?hash=item2cc23c08fd:g:dpsAAOSw2xRYYxVt)

setup - At home , transmitter at second floor receiver basement.

Can somebody confirm the purpose of two antennas?

thanks

---

_[View the full topic](https://www.thethingsnetwork.org/forum/t/big-esp32-sx127x-topic-part-1/10247)._
