Hello: Can someone point me to a “node” sketch that absolutely works on a “Dragino LoRa Shield v1.4” attached to a “Arduino Uno R3” using 915mhz? I have tried numerous of tutorials and their sketches but have not been able to get my node “seen” on TTN - the device status is always “never seen”. P…

I could kiss you!!! :slight_smile: :slight_smile: (figure of speach) I don’t believe it but IT IS WORKING!!! [image] That means that it is working, right? I really, really appreciate the time and effort you put into your reply. I have been working on this for weeks now - I still can’t believe…

[image] robertthompson: I have been working on this for weeks now - I still can’t believe that it is working… Well if you have a solution,be sure to tell Dragino, it could help so many people solve the same problem …

CurlyWurly explained it clearly … dragino should indeed edit their wiki’s

Sorry. My internet is down since Sunday. Will properly test and respond. Rob. (from Internet Cafe)

Hopefully things are working well Rob when you get your internet back and a chance to test. Things here in Montreal seem to be working well with the above set up at the moment. Still can’t get the slightly more expensive piece of junk LG-01 to work, though that may be from my own issues.

Quick question, I see in frequency in TTN, you have 915. How did you set your freq in the LG01 ? I am able to make my nodes and gateways working on single 902300000 freq but not sure how you did it on LG01.

Hey guys, I am using the same things for my node Arduino UNO R3, Dragino Shield v1.4), and I have followed your code and instruction (except for 4th), but I still get the same result. my device is still not seen on TTN, but after following the instructions my serial output is this: Starting Packe…

The config.h file is from the LMIC library, assuming you are using the Arduino IDE, you should see a LMIC folder in the libraries folder. In my case on a Win10 machine the config.h file is located at this path: C:\Users<user name>\Documents\Arduino\libraries\IBM_LMIC_framework\src\lmic\config.h If…

Thanks, I have already done the Change, last night I followed this tutorial, and I got result. The tutorial I followed. http://thomaslaurenson.com/projects/DraginoLoRaShield.html After 10 minutes the device was seen on thethingsnetwork. JUST for a MINUTE. and they have been disconnected since tha…

What gateway are you using? Also is your node sending out data on one single channel by modifying the limc.c file like is shown previously in this thread or did you not edit it which means it will continue to loop through the available channels looking to connect to a gateway?

Need professional support?

The Things Network

Node: Need a sketch that works with Dragino LoRa Shield & Arduino Uno

End Devices (Nodes) Dragino