Yes : voltages to folllow the battery level , Temperatures : inside and outside hive, humidity inside and outside , rain , bee counter
Not all sensors are implemented at each time. You have to configure your equipment according to what you want to know. You may implement up to 4 to 6 scales but there are some limitations (in terms of data volume) on TTN that prevent to send it too frequently ; in this case, it is longer to detect a swarm .
It is a compromise you have to establish .
Thanks for the interesting discussion, I am looking forward to your note and continue to look after the bug. I will keep you informed anyway
In the meanwhile, you could try adding the device again, but ensuring you check the Resets Frame Counters - it doesn’t work so well if you do it after you’ve created the device.
And these are ALL of the EU frequencies (which also apply to UK, Swiss & EEA Bees).
Sorry, I didn’t catch the accuracy of your question : on the concerned device, I have 2 scales , 1 voltage, 1 T° , that is to say 30 or 33 bytes for payload .
Is it the responses you expect ?
Here is one received message copied from the gateway console V3:
19:36:17 Receive uplink message DevAddr 260BA800 FPort 1
MAC payload A519304F80688C42BB2F21539A0A063BC30D0BA1
Bandwidth 125000
SNR 7.5
RSSI -31
Raw payload 4000A80B2680000001A519304F80688C42BB2F21539A0A063BC30D0BA10A5BCD2F
DHT 21/22 is configured but I don’t implement it .
I use the T° information from the DS3231 module (RT clock)
For Volt, Nano board analog input are used.
I have to go on the hives but the weather is really poor (let’s say a bit Brit…). We will have to wait until bees can go out also …
I will have the time to read more .
Thanks anyway
This was the right direction : with an updated library ,tonight i have some better results. Some messages are properly decoded at the level of the console. They do not reach my server presently but it’s a great step already. Tomorrow is an other day !
Thanks for your help. It has been a pleasure to fly with you a moment.
See you later.
Analog out fort Volts, luminosity for Weight, T° for Temperature. This work fine now with the proper LMIC library .
Now I have to understand why I cannot read the MQTT server V3 such as in V2 . But this is an other topic , if I have well understood.
Bye on that one.