[solved] Elecrow Lora node radio v1.0

[BoRRoZ]

I searched and can’t find more info from this elecrow board.
Don’t know if the pinmappings in the code are correct, maybe need to mount an extra wire, only thing I see is that you are very close to your gateway with this node

• update

found this

New ATmega328 LoRa board by Elecrow

Yesterday I’ve got a new development board from elecrow. [IMG_3703] unfortunately only DIO0 is connected to the µController. So i had to connect DIO1 pin at he RFM96 to unused pin 5 at the Atrmega328P to get the arduino lmic otaa example running. The pin mapping is const lmic_pinmap lmic_pins = { .nss = 10, .rxtx = LMIC_UNUSED_PIN, .rst = LMIC_UNUSED_PIN, .dio = {2, 5, LMIC_UNUSED_PIN}, }; Seems to use about 45µA in deep sleep mode - not bad To get further a schematic…

uncle Ali:
https://www.aliexpress.com/item/868mhz-LoRa-Radio-Node-V1-0-IOT-Lora-Module-RFM95-SX1276-for-Arduino-ATmega328P-3-7/32971081613.html