[SOLVED] Setup Tabs GPS sensor & Ubidots

[arjanvanb (Arjan)]

An example from Ubidots on the forum uses the following JSON format:

@ubidots

JSON payload returned by the decoder:

{
  "position": {"lat": 6.32122, "lng": -75.23234},
  "alarm": false,
  "batV": 2.761,
  "pitch": 4.57,
  "roll": 0.83
}

So, maybe remove the excessive "lat" and "lon" properties that are on the JSON’s root level in your output? (Also note the "lon" vs "lng".)

Also, an October 2019 screenshot in the same post shows “Location Mode: auto”, and does not define an orange “Variable” box for the position value. What if you remove that? (Maybe explicitly mapping the position variable stops it from being used for the map?)