Change Spreading Factor manualy

[bertrik]

I have used the TBMS100 sensors and I’ve seen them change SF based on ADR.

So this should just work, maybe needs a little patience.

You should be able to trigger a remote reboot of the sensors, as described in this post:

Migrating TABS/Browan sensors - remote reboot to trigger OTAA

As noted in Migrating OTAA Devices from V2 to V3 one of the critical steps in performing the migration of devices is to trigger a new OTAA on the device, so the device receives a new device address / session keys and new network parameters from the TTN “v3” stack. A new OTAA is done for these devices after a reboot or power-cycle. I have a couple of TBMS100 (motion) and TBHV100 (temperature/humidity) nodes deployed in a location where I cannot easily access them to reboot them by means of a pow…