Hello, I am currently working on a project using LoRa technology. My end node is composed of Nucleo-l073rz and i-Nucleo-lrwan1 shield and I am also using Keil IDE. So here’s the problem: I installed the I Cube Lrwan expansion ( I tried both V1.3.1 and the latest one which is the V2.0.0 and even ol…

The problem in the downlink in the V3 is that it uses a 5 seconds Rx1 delay and the V2 uses 1 second RX1 delay. So try to set in your arduino script the RX1Delay to 5 seconds, just add in the void setup this line : loraNode.setRx1Delay(5000);

Learn

Hardware

Device Repository The Things Shop

Forum Community Conference Enterprise

Need professional support?

The Things Network

I Cube LRWAN problem

End Devices (Nodes)

← previous page

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled