I have a kona home sensor that I have added to my network of LoRaWAN devices. After adding it I observe that it appears in the gateway traffic but I was not able to add it correctly to the application because it appears as “never seen”. I have followed the following steps: I have created a new app…

Post some of the raw packet contents and metadata as sent as seen by your gateway.

[image] manu08: I have created a new application, to which I have changed the AppEUI to match the one that comes in the sensor. Next, I have added the device with the corresponding DevEUI. What about the secret AppKey? See also Registration of node with pre-configured LoRaWAN keys .

See the following post: [image] Tektelic Smart Room Sensor (aka Kona Home Sensor) For registering the device in your own application the below three keys are needed. Easiest is to create a new application in the console. The AppEUI from the device must be added to your LoRaWAN application. The …

Kona home sensor appears status "never seen"

End Devices (Nodes)

arjanvanb (Arjan) September 9, 2020, 9:21pm 4

What about the secret AppKey? See also Registration of node with pre-configured LoRaWAN keys.