Starting out with an Arduino Uno and Dragino LoRa shield

[mickvde]

@cslorabox

With modern TTN, really your only viable software choice on that hardware is a recent checkout of MCCI LMiC (or something wrapping it), carefully set to a minimal configuration to fit within the Uno’s memory constraints (the Uno/ATmega328 is no longer a recommended platform for LoRaWAN at all, but it can still barely fit).

I saw this library and have attempted to use it. I do unfortunately keep receiving “noJoinAccept” messages when I look at the serial monitor. I’ve read online that this most likely has to do with using the wrong values for the frequency plan, regional paramaters and/or lorawan version.

I also read that this should be provided in a datasheet, I’ve found the datasheet for the LoRa shield v1.4 but it does unfortunately not contain that information.

Do you know the correct regional parameters (for EU), or know where I can find them?

EDIT: I did replace all the necessary information (AppKey etc) in the sketch with the values of the end device that I created in TTN.

Thanks in advance.